LED Strip COB NEON 1260 / 12 VDC / 1m – Neutral White

LED Strip COB NEON 1260 / 12 VDC / 1m – Neutral White

This innovative LED strip is made using COB (Chip-on-Board) technology. The connectors are placed at a density of 528pcs/m, ensuring a continuous line of light without any visible points. The self-adhesive 3M LSE mounting tape is pre-applied to the back of the strip for easy installation.

The high-brightness diodes offer a wide viewing angle and an extended lifespan, ensuring long-term, trouble-free performance. The strip can be cut into shorter sections, with each segment consisting of 24 diodes, and a minimum length of 45.45mm. The tape measures 8mm in width and comes in a 1m length.

To ensure the longevity of the strip, proper heat dissipation at the mounting location is essential. The surface where the tape is mounted should be clean, free from dust, dirt, and properly degreased.

The tape operates on a 12V DC supply, and the connection points are clearly marked for proper installation.

Important Notes:

• Do not connect the strip directly to a 230V power source as it may cause electric shock or damage the product.
• For optimal performance, use a stabilized DC power supply, ensuring the power supply has at least 20% more capacity than the tape’s nominal power rating.
• LED strips should not exceed 1m in length in a single section. Longer installations must be powered from both ends or in multiples of 5m to avoid voltage drops and ensure the rated lifespan.
• The tape has an IP20 protection rating, making it suitable for indoor use in dry, dust-free environments.
• Cutting the strip should only be done along the designated cutting marks. Cutting outside these areas may damage the strip. Always turn off the power before cutting.

Ensure your electrical installation has proper short circuit, overload, and overvoltage protection when mounting the LED strip.